Residential Generator Maintenance

Service Department Highlights:

• Residential, commercial & industrial capabilities
• 24/7 Emergency response
• Factory & rigorous in house training
• Servicing all major brands
• Flat rates for most standard repair services

Generator Maintenance Services:

• Preventative Maintenance Agreements packages for the most comprehensive level of service
• Extended warranties
• Routine maintenance services
• Load bank services (extend the life of your generator by preventing wet-stacking)
• Repair services from 8kW to over 2MW!
• Factory start-ups
• Fuel Polishing
• Remote Monitoring
• Warranty repairs on most major brands

 

	Generator Maintenance Plans
	SERVICE PLAN DETAILS SILVER GOLD PLATINUM FULL INSPECTION (See Points of Inspection): 2 x 3 x 4 x Oil & Oil Filter Replacement: 1 x 1 x 1x Battery Replacement***: EVERY TWO YEARS EVERY TWO YEARS EVERY TWO YEARS Remote Monitoring: NOT INCLUDED NOT INCLUDED INCLUDED Fan Belt Replacement (If Applicable): NOT INCLUDED NOT INCLUDED 1x Coolant Flusht (If Applicable): NOT INCLUDED NOT INCLUDED 1x PARTS & LABOR (Not under warranty): 5% Parts Discount 10% Parts Discount 15% Parts Discount Generator Test Under Load**: 1 x 1 x 2 x Office Emergency Response Time: 24 Hours 24 Hours 12 Hours Gas System Pressure Test: 1 x 1 x 1 x   Generator Maintenance Cost AIR-COOLED UP TO 26KW $495 $695 $1,350 LIQUID-COOLED UP TO 60KW $595 $850 $1,550 LIQUID COOLED 61-150KW $695 $950 $1,750
	Full Agreement (PDF) → | Sign Agreement Online →

 

Standard Points of Inspection*

Pre-Start Generator Checks:

• Inspect Generator Control Panel
• Check Run History on Controller
• Inspect Fuel Lines & Connections
• Inspect Fuel Level
• Inspect Oil Level & Condition
• Inspect Leaks
• Inspect Accessory Drive Belts
• Inspect Hoses & Clamps
• Inspect Coolant Level & Cap
• Inspect Air Inlets & Clear Debris
• Check Wiring for Loose Connections, Corrosion & Damage
• Clean & Tighten Battery Terminals
• Check Battery Charge State
• Gas Pressure Test
• Clean Exterior & Interior of Generator

Pre-Start Transfer Switch Checks:

• Inspect Dead Front & Cover
• Remove Dust. Debris & Grease
• Check Wiring for Loose Connections, Corrosion & Damage
• Inspect Fuses. Relays & Breakers

Tune Up (If Applicable):

• Change Engine Oil with Synthetic
• Replace Oil Filter
• Replace Air Filter, if needed
• Replace Spark Plugs
• Check Wiring for Loose Connections. Corrosion & Damage
• Clean & Tighten Battery Terminals
• Transfer Power (If ATS Accessible) for 10 Minutes

Generator Operations Checks:

• Check Battery Charge State
• Check Battery Cranking Voltage
• Gas Pressure Test
• Check Generator Voltage, and Amperage Output
• Check Fuel Pressure Under Load
• Clean Exterior & Interior of Generator
• Run 5 Minutes No Load

_{*Points of inspection may be modified as needed for various system requirements.
** Customer must agree to be home to avoid damage to sensitive equipment.
***Batteries are now a part of all contracts. Batteries are the #1 cause of generator failures in a power outage!}